• Home
  • List of Papers
  • Optimization of Endmill Cutting Conditions for Nickel-Based Super Alloys

Optimization of Endmill Cutting Conditions for Nickel-Based Super Alloys

Abstract

Parameter design based on the Taguchi Method was applied to the endmill cutting process for nickel-based super alloys rather than the conventional sequential methods or experimental design methods in order to optimize the cutting conditions.“Machining transferability”, which compares the preset removal volume to the actual removed volume, was selected as the evaluation characteristic used in this method.As a result, if an alloy is cut with the optimized conditions obtained with parameter design, an approximately 60% reduction in variations in machining transferability, in terms of the standard deviation, can be achieved as compared to the conventional conditions.

References

  1. (1) K. Fujimoto, K. Fujikake, R. Fujimoto, K. Higashihara and K. Takahashi: Optimization of Ti High Speed Cutting Process, 6th Quality Engineering Research Presentation Conference, Collection of Papers, p.173-178 (1998).
  2. (2) T. Wagou: Optimization of Endmill Cutting for Hardened Steel, 7th Quality Engineering Research Presentation Conference, Collection of Papers, p.189-192 (1999).
  3. (3) K. Ichikawa, S. Kazashi, M. Toushi and N. Sumita: A Study on the Evaluation Method for the Function of a Turning Process Through the Measurement of Energy Consumed During OFF and ON Mode, Quality Engineering, Vol.8, No.1, p.38-42 (2000).
  4. (4) K. Takahashi, S. Kousaka, K. Hoshiya, K. Yano, N. Nishiuchi and H. Yano: Optimization of Machining Conditions Through the Observation of Electric Power Consumption, Quality Engineering, Vol.8, No.1, p.24-30 (2000).
  5. (5) Z. Nakaya, T. Sagiya, S. Xu, S. Kajiura, M. Horikawa, A. Takakura, A. Sugiyama and N. Hori: Optimization of high-speed-ball-end-milling conditions for medium hardened steels, 7th Quality Engineering Research

Author (organization or company)

Publication Information

Article of Honda R&D Technical Review Vol.12 No.2 (87 - 92)

PDF

PDF 156KB

Citation Information

Sachio KAJIURA, Yasuhiko JINBU, Kazuya KUWABARA.
Optimization of Endmill Cutting Conditions for Nickel-Based Super Alloys
Honda R&D Technical Review Vol.12 No.2 pp.(87 - 92)2000.
Copy citation information
Copied